Dell Chassis Management Controller Version 3.10 for PowerEdge VRTX RACADM CLI Guide

getniccfg

Table 1. getniccfg. The following table contains the description, synopsis, and input of the `getniccfg` command.
Description	Displays the current NIC settings.
Synopsis	racadm getniccfg
Input	racadm getniccfg racadm getniccfg –m <module> where –m must be one of the following values: chassis : default state if -m is not specified server-n : where n = 1 to 4 switch-n : where n = 1
Example	`racadm getniccfg` NIC Enabled = 1 IPv4 Enabled = 1 DHCP Enabled = 1 Static IP Address = 192.168.0.120 Static Subnet Mask = 255.255.255.0 Static Gateway = 192.168.0.1 Current IP Address = 10.94.225.212 Current Subnet Mask = 255.255.255.128 Current Gateway = 10.94.225.129 IPv6 Enabled = 0 Autoconfiguration Enabled = 1 Static IPv6 Address = ::/64 Static IPv6 Gateway = :: Link Local Address = :: Current IPv6 Address 1 = :: Current IPv6 Gateway = :: Speed = Autonegotiate Duplex = Autonegotiate VLAN Enable = 0 VLAN ID = 1 VLAN priority = 0 `racadm getniccfg -m server-3` LOM Model Name = BRCM GbE 4P 5720 bNDC LOM Fabric Type = Gigabit Ethernet IPv4 Enabled = 1 DHCP Enabled = 0 IP Address = 0.0.0.0 Subnet Mask = 0.0.0.0 Gateway = 0.0.0.0 IPv6 Enabled = 0 Autoconfiguration Enabled = 1 Link local Address = IPv6 Gateway = :: VLAN Enable = 0 VLAN ID = 1 VLAN priority = 0 `racadm getniccfg -m switch-1` DHCP Enabled = 0 IP Address = 0.0.0.0 Subnet Mask = 0.0.0.0 Gateway = 0.0.0.0