Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware m17 R2 Service Manual

PDF

Installing the fan and heat-sink assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

CAUTION: If either the processor or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.

About this task

The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.

Image: Installing the fan and heat-sink assembly

Steps

  1. Place the fan and heat-sink assembly on the system board.
  2. In sequential order (1>2>3>4>5>6) replace the six screws (M2x3) that secure the fan and heat-sink assembly to the system board.
  3. Connect the left and right fan cables to the system board.

Next steps

  1. Install the system board.
  2. Install the battery.
  3. Install the rear I/O-cover.
  4. Install the 2230 solid-state drive. (if applicable)
  5. Install the 2280 solid-state drive. (if applicable)
  6. Install the base cover.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\