Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware m17 R2 Service Manual

PDF

Removing the rear I/O-cover

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

The following image indicates the location of the rear I/O-cover and provides a visual representation of the removal procedure.

Image: Removing the rear I/O-cover

Image: Removing the rear I/O-cover

Steps

  1. Peel and lift the Mylar covering the system board.
  2. Disconnect and peel the Tron light cable from the system board and route the cable through the slot on the Mylar.
    NOTE: To prevent damaging your computer ensure the Tron light cable has been disconnected from the system board before removing the rear I/O-cover.
  3. Remove the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest assembly.
  4. Firmly grasp the sides of your computer with both hands and push the rubber feet on the rear I/O-cover outwards with your thumbs to release the rear I/O-cover from the palm-rest assembly.
  5. Lift the rear I/O-cover from the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\