Dell Command | Configure Version 4.2 Release Notes

Fix: Dell Command | Configure sets an unknown password for the BIOS issue has been resolved.

Description: While running the following command cctk.exe --setuppwd --valsetuppwd=abcd1234, Dell Command | Configure displays Only validation option. No actions will be performed. Password is set successfully message issue has been resolved now.

Fix: Local package takes few seconds to load for the first time issue has been resolved.

Description: Once you launch the GUI Application for the first time, the local system package takes few seconds to load. As a result of that, the application takes few seconds to display the data grid. This delay is not observed during the next cycle onwards issue has been resolved now.

Fix: GUI Application takes few seconds to exit if closed immediately after launch issue has been resolved.

Description: Once you launch the GUI Application and close it immediately, the closure is delayed by few seconds. This happens for the first time and is not observed during the next cycle onwards issue has been resolved now. 

Fix: Issue in validating the feature for non enum types has been resolved.

Fix: Issues observed on the platforms where System and Setup Passwords are not supported has been resolved.

Fix: Dell Command | Configure SCE crashes once you enter " in any of the following fields: Passwords, Asset, or PropOwntag issue has been resolved.