Delete devices that are recovered onto your NetWorker server
After an automated NetWorker recovery using the
Cyber Recovery software completes, manually delete devices that the procedure recovered onto your NetWorker server.
About this task
Your NetWorker server might include other devices that were there before the
Cyber Recovery backup recovery job.
NOTE Only delete devices that the
Cyber Recovery software recovered onto your NetWorker server. Ensure that you do not delete devices that you must keep.
Steps
Unmount the NetWorker sandbox from the
Cyber Recovery management host:
umount /opt/dellemc/cr/mnt/cr-rec-ldpda240_1604
Go to the NetWorker UI.
From the
Protection tab, perform the following tasks:
Delete newly added clients.
Delete newly added policies.
Delete newly added groups.
Delete any other newly added protection types.
From the
Devices tab, perform the following tasks:
Delete newly added devices.
Delete newly added
DD system.
Delete newly added storage nodes (if necessary).
From the
Media tab, perform the following tasks:
Delete newly added disk volumes.
Delete newly added media pools.
Delete any other newly added media types.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\