Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Configuration Guide for the S4048–ON System 9.14.2.5

PDF

Configuring and Adding the Member VLANs

Control and member VLANS are configured normally for Layer 2. Their status as Control or Member is determined at the FRRP group commands.

For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.
Be sure to follow these guidelines:
  • All VLANS must be in Layer 2 mode.
  • Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged or untagged.
  • The control VLAN must be the same for all nodes on the ring.

To create the Members VLANs for this FRRP group, use the following commands on all of the Transit switches in the ring.

  1. Create a VLAN with this ID number.
    CONFIGURATION mode.
    interface vlan vlan-id
    VLAN ID: the range is from 1 to 4094.
  2. Tag the specified interface or range of interfaces to this VLAN.
    CONFIG-INT-VLAN mode.
    tagged interface {range}
    Interface:
    • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
    • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  3. Assign the Primary and Secondary ports and the Control VLAN for the ports on the ring.
    CONFIG-FRRP mode.
    interface primary interface secondary interface control-vlan vlan id
    Interface:
    • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
    • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
    VLAN ID: Identification number of the Control VLAN.
  4. Configure a Transit node.
    CONFIG-FRRP mode.
    mode transit
  5. Identify the Member VLANs for this FRRP group.
    CONFIG-FRRP mode.
    member-vlan vlan-id {range}
    VLAN-ID, Range: VLAN IDs for the ring’s Member VLANs.
  6. Enable this FRRP group on this switch.
    CONFIG-FRRP mode.
    no disable

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\