Dell Configuration Guide for the S4048–ON System 9.14.2.5

Resetting an Interface to its Factory Default State

You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the following steps:

1. View the configurations applied on an interface.
   INTERFACE mode
   show config

    DellEMC(conf-if-te-1/5)#show config 
    !
    interface TenGigabitEthernet 1/5
    no ip address
    portmode hybrid
    switchport
    rate-interval 8
    mac learning-limit 10 no-station-move
    no shutdown
   

2. Reset an interface to its factory default state.
   CONFIGURATION mode
   default interface interface-type]

   DellEMC(conf)#default interface tengigabitethernet 1/5

3. Verify the configuration.
   INTERFACE mode
   show config

   DellEMC(conf-if-te-1/5)#show config 
   !
   interface TenGigabitEthernet 1/5
    no ip address
    shutdown
   

   All the applied configurations are removed and the interface is set to the factory default state.