Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC OpenManage Enterprise Version 3.5 User's Guide

PDF

Run remote–RACADM and IPMI–commands on individual devices

RACADM and IPMI commands can be sent to a device's iDRAC from the 'Device name' page to remotely manage the respective device.
NOTE Using the RACADM CLI only allows for one command at a time.
  1. Select the check box corresponding to the device and click View Details.
  2. On the <device name> page, click Remote Command Line, and then select RACADM CLI or IPMI CLI.
    NOTE The RACADM CLI tab is not displayed for the following servers because the corresponding task is not available in the device pack — MX740c, MX840c, and MX5016S.
  3. In the Send Remote Command dialog box, type the command. Upto 100 commands can be entered with each command required to be on a new line. To display the results in the same dialog box, select the Open results after sending check box.
    NOTE Enter an IPMI command in the following syntax: -I lanplus <command> . To end the command enter 'Exit.'
  4. Click Send.
    A job is created and displayed in the dialog box. The job is also listed on the Job Details. See View the jobs list.
  5. Click Finish.
    The Recent Alerts section displays the job completion status.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\