Configuring ACL VLAN Groups and Configuring FP Blocks for VLAN Parameters
This section describes how to optimize CAM blocks by configuring ACL VLAN groups that you can attach to VLAN interfaces. It also describes how to configure FP blocks for different VLAN operations.
Configuring ACL VLAN Groups
You can create an ACL VLAN group and attach the ACL with the VLAN members. The optimization is applicable only when you create an ACL VLAN group.
Create an ACL VLAN group.
CONFIGURATION mode
acl-vlan-group {group name}
Add a description to the ACL VLAN group.
CONFIGURATION (conf-acl-vl-grp) mode
description
description
Add VLAN member(s) to an ACL VLAN group.
CONFIGURATION (conf-acl-vl-grp) mode
member vlan {VLAN-range}
Display all the ACL VLAN groups or display a specific ACL VLAN group, identified by name.
CONFIGURATION (conf-acl-vl-grp) mode
show acl-vlan-group {group name | detail}
DellEMC#show acl-vlan-group detail
Group Name :
TestGroupSeventeenTwenty
Vlan Members :
100,200,300
Group Name :
CustomerNumberIdentificationEleven
Vlan Members :
2-10,99
Group Name :
HostGroup
Vlan Members :
1,1000
DellEMC#
Configuring FP Blocks for VLAN Parameters
To allocate the number of FP blocks for the various VLAN processes on the system, use the
cam-acl-vlan command. To reset the number of FP blocks to the default, use the
no version of this command. By default, 0 groups are allocated for the ACL in VLAN contentaware processor (VCAP). ACL VLAN groups or CAM optimization is not enabled by default. You also must allocate the slices for CAM optimization.
Allocate the number of FP blocks for VLAN operations.
CONFIGURATION mode
cam-acl-vlan vlanopenflow <0-2>
Allocate the number of FP blocks for VLAN iSCSI counters.
CONFIGURATION mode
cam-acl-vlan vlaniscsi <0-2>
Allocate the number of FP blocks for ACL VLAN optimization.
CONFIGURATION mode
cam-acl-vlan vlanaclopt <0-2>
View the number of FP blocks that is allocated for the different VLAN services.