Dell Command Line Reference Guide for the S4048–ON System 9.14.2.6

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.3.(0.0)

Introduced on the S4810, S4820T, Z9000 and MXL platforms

After CAM configuration for ACL VLAN groups is performed, you must reboot the system to enable the settings to be stored in nonvolatile storage. During the initialization of CAM, the chassis manager reads the NVRAM and allocates the dynamic VCAP regions.

The following table describes the output fields of this show command:

Field

Description

Chassis Vlan Cam ACL

Details about the CAM blocks allocated for ACLs for various VLAN operations at a system-wide, global level.

Stack Unit <number>

Details about the CAM blocks allocated for ACLs for various VLAN operations for a particular stack unit.

Current Settings(in block sizes)

Information about the number of FP blocks that are currently in use or allocated.

VlanOpenFlow

Number of FP blocks for VLAN open flow operations.

VlanIscsi

Number of FP blocks for VLAN internet small computer system interface (iSCSI) counters.

VlanHp

Number of FP blocks for VLAN high performance processes.

VlanFcoe

Number of FP blocks for VLAN Fiber Channel over Ethernet (FCoE) operations.

VlanAclOpt

Number of FP blocks for ACL VLAN optimzation feature.

DellEMC# show cam-acl-vlan 

-- Chassis Vlan Cam ACL --
             Current Settings(in block sizes) 
VlanOpenFlow :         0
VlanIscsi    :         0
VlanAclOpt   :         2
VlanHp       :         1
VlanFcoe     :         1
DellEMC#