Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

application

Configure the management egress interface selection.

Syntax
application {all | application-type}

To remove a management application configuration, use the no application {all | application-type} command.

Parameters
application-type
Enter any of the following keywords:
  • For DNS, enter the keyword dns.
  • For FTP, enter the keyword ftp.
  • For NTP, enter the keyword ntp.
  • For Radius, enter the keyword radius.
  • For sFlow collectors, enter the keyword sflow-collector.
  • For SNMP (traps and MIB responses), enter the keywords snmp .
  • For SSH, enter the keyword ssh .
  • For Syslog, enter the keyword syslog.
  • For TACACS, enter the keyword tacacs.
  • For Telnet, enter the keyword telnet.
  • For TFTP, enter the keyword tftp.
all
Configure all applications.
Defaults
None.
Command Modes
EIS Mode (conf-mgmt-eis)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.2.(0.0)
Introduced on the Z9000, S4810, and S4820T.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\