- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Coin-cell battery
- Wireless card
- Memory modules
- Solid-state drive in SSD1 slot
- Solid-state drive in SSD2 slot
- Hard drive
- Speakers
- Rear cover
- Rear-cover bracket
- Processor fan
- Graphics-card fan
- Heat sink
- I/O board
- G key
- Display assembly
- Power button with fingerprint reader
- Power-adapter port
- Light bar
- System board
- Touchpad
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Dell G7 17 7700 Service Manual
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.
Steps
- Adhere the coin-cell battery to the palm-rest and keyboard assembly.
- Route the coin-cell battery cable under the speaker cable and through the routing guides.
- Connect the coin-cell battery cable to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\