- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Coin-cell battery
- Wireless card
- Memory modules
- Solid-state drive in SSD1 slot
- Solid-state drive in SSD2 slot
- Hard drive
- Speakers
- Rear cover
- Rear-cover bracket
- Processor fan
- Graphics-card fan
- Heat sink
- I/O board
- G key
- Display assembly
- Power button with fingerprint reader
- Power-adapter port
- Light bar
- System board
- Touchpad
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Dell G7 17 7700 Service Manual
Installing the graphics-card fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the graphics-card fan and provides a visual representation of the installation procedure.
Steps
- Align the screw holes on the graphics-card fan with the screw holes on the system board and the palm-rest and keyboard assembly.
- Replace the three screws (M2x4) that secure the graphics-card fan to the system board and the palm-rest and keyboard assembly.
- Connect the graphics-card fan cable to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\