dcismcfg utility is used to enable or disable the Historic S.M.A.R.T log collection feature. This utility is supported on all operating systems. Once the utility is used to enable or disable the Historic S.M.A.R.T log collection feature, the next polling cycle of S.M.A.R.T Monitoring fulfills the request.
Run the following commands to enable or disable the Historic S.M.A.R.T log collection:
For Windows run either one of the following commands:
dcismcfg utility must run as an administrator or root user and is supported for iDRAC firmware version 4.40.00.00 and later.
NOTE Historic S.M.A.R.T log collection is a subfeature of S.M.A.R.T Monitoring feature. However, while enabling Historic S.M.A.R.T log collection, if S.M.A.R.T Monitoring feature is not enabled, you are prompted to enable S.M.A.R.T Monitoring in order to enable Historic log collection.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\