You can configure the Redfish interface on iDRAC
by enabling or disabling the iDRAC attribute. If this attribute is
disabled, HTTPS requests to Redfish URIs fail with an HTTP status
code of 404 and an error message indicating that this attribute is disabled.
NOTE: You do not need to restart the web server when enabling or disabling
Redfish attribute.
Configuring Redfish service using iDRAC web interface
To enable or disable the Redfish service on iDRAC, perform the following tasks:
In the iDRAC
web interface, navigate to the following screen:
Under Redfish, select Enabled and click Apply to enable the service.
Configuring Redfish service by using iDRAC
RACADM
You can enable or disable the Redfish
service using the iDRAC attribute iDRAC.Redfish.Enable (Read
or Write)iDRAC.Redfish.Enable (Read
or Write).
Configuring Redfish service
by using WS-MAN
The Redfish attribute iDRAC.Redfish.EnableiDRAC.Redfish.Enable is modeled under the existing DCIM_iDRACCardEnumerationDCIM_iDRACCardEnumeration class. You can configure the Redfish
service using existing methods such as SetAttribute, SetAttributes,
and ApplyAttributes of DCIM_iDRACCardServiceDCIM_iDRACCardService class.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\