- Notes, cautions, and warnings
- Copyright
- Safety instructions
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Memory modules
- WLAN card
- Solid-state drive
- Hard drive
- Speakers
- Graphics Processing Unit (GPU) fan
- CPU fan
- Heat sink
- Coin-cell battery
- I/O board
- Power button with optional fingerprint reader
- Power-adapter port
- Touchpad
- Display assembly
- Display bezel
- System board
- Palm-rest and keyboard assembly
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7591 Service Manual
Installing the M.2 2280 solid-state drive
If you are replacing a component, remove the existing component before performing the installation procedure.
The figure indicates the location of the solid-state drive bracket and provides a visual representation of the bracket alignment procedure to accommodate the M.2 2280 solid-state drive.
NOTE: : The computer is shipped with solid-state drive shield, only if the solid-state drive capacity is more than 512 GB.
The figure indicates the location of the solid-state drive and provides a visual representation of the installation procedure:
- If required, align the solid-state drive bracket to accommodate the M.2 2280 solid-state drive.
- Align the notch on the solid-state drive module with the tab on the solid-state drive slot.
- Slide the solid-state drive module firmly into the solid-state drive slot at an angle.
- Secure the tab on the solid-state drive slot with the slot on the solid-state drive bracket.
- Replace the two screws (M2x4) that secure the solid-state drive module shield to the palm-rest and keyboard assembly.
- Connect the battery cable.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\