Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

PDF

Configuring BIOS For Serial Connection

To configure BIOS for Serial Connection:
  • NOTE: This is applicable only for iDRAC7 on rack and tower servers.
  1. Turn on or restart the system.
  2. Press <F2>.
  3. Go to System BIOS Settings > Serial Communication .
  4. Specify the following values:
    • Serial Communication — On With Console Redirection
    • Serial Port Address — COM2.
      • NOTE: You can set the serial communication field to On with serial redirection via com1 if serial device2 in the serial port address field is also set to com1.
    • External serial connector — Serial device 2
    • Failsafe Baud Rate — 115200
    • Remote Terminal Type — VT100/VT220
    • Redirection After Boot — Enabled
  5. Click Back and then click Finish.
  6. Click Yes to save the changes.
  7. Press <Esc> to exit System Setup.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\