PowerScale OneFS CLI Administration Guide

Set the cluster date and time

You can set the date, time, and time zone for the PowerScale cluster.

1. Run the isi config command.
   The command-line prompt changes to indicate that you are in the isi config subsystem.
2. Specify the current date and time by running the date command.
   The following command sets the cluster time to 9:47 AM on July 22, 2015:

   date 2015/07/22 09:47:00

3. To verify your time zone setting, run the timezone command. The current time zone setting displays. For example:

   The current time zone is:  Pacific Time Zone

4. To view a list of valid time zones, run the help timezone command. The following options display:

   Greenwich Mean Time
   Eastern Time Zone
   Central Time Zone
   Mountain Time Zone
   Pacific Time Zone
   Arizona
   Alaska
   Hawaii
   Japan
   Advanced

5. To change the time zone, enter the timezone command followed by one of the displayed options.
   The following command changes the time zone to Hawaii:

   timezone Hawaii

   A message confirming the new time zone setting displays. If your desired time zone did not display when you ran the help timezone command, enter timezone Advanced. After a warning screen, you will proceed to a list of regions. When you select a region, a list of specific time zones for that region appears. Select the desired time zone (you may need to scroll), then enter OK or Cancel until you return to the isi config prompt.
6. Run the commit command to save your changes and exit isi config.