- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of Latitude 9330
- SIM card tray
- Base cover
- Battery
- M.2 solid-state drive
- Wireless Wide Area Network (WWAN) card
- Fan
- Heat sink
- Display assembly
- Speakers
- WLAN-antenna module
- System board
- Power button with fingerprint reader
- Keyboard
- Palmrest
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 9330 Service Manual
Installing the base cover
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Steps
- Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place.
NOTE: When installing the base cover, press down on the cover near the model name until you hear a click to ensure that the hook on the cover fits securely into the stud on the palm-rest.
- Tighten the eight captive screws to secure the base cover to the palm-rest and keyboard assembly.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\