- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of Latitude 9330
- SIM card tray
- Base cover
- Battery
- M.2 solid-state drive
- Wireless Wide Area Network (WWAN) card
- Fan
- Heat sink
- Display assembly
- Speakers
- WLAN-antenna module
- System board
- Power button with fingerprint reader
- Keyboard
- Palmrest
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 9330 Service Manual
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
Steps
- Align and place the power-button assembly on the palm-rest and keyboard assembly.
- Replace the two (M1.6x2.3) screws to secure the power-button assembly to the palm-rest and keyboard assembly.
Next steps
- Install the system board.
- Install the heat sink.
- Install the battery.
- Install the WWAN card.
- Install the base cover.
- Install the SIM card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\