Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 3510 Service Manual

PDF

Removing the IO Board

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD Card.
  3. Remove the base cover.
  4. Disconnect the battery.
  5. Remove the WLAN card.
  6. Remove the WWAN card.
NOTE Hall Sensor is a part of the IO board and the entire IO board needs to be replaced if the Hall Sensor is faulty.

About this task

The following images indicate the location of the memory module and provide a visual representation of the removal procedure.

IO Board remove

Steps

  1. Remove the three (M2x3) screws from the left hinge and lift the hinge up.
  2. Peel back the adhesive tape covering the IO board connector cable and disconnect it from the system board.
  3. Disconnect the cable connectors from the IO board in the following order (left - right): USB data cable, Coin-cell battery cable, Audio FFC cable.
  4. Remove the single (M2x5) screw that is holding the IO board in place and lift the module away from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\