CAUTION: : Disconnect
the power cord before removing the power supplies. Also, disconnect
all power cords before servicing.
NOTE: : The PSU slides into
the slot smoothly. Do not force a PSU into a slot as this action may
damage the PSU or the S5048F-ON switch.
NOTE: : If a PSU fails, you
must replace the entire unit. There are no field serviceable components
in the PSU. To request a hardware replacement, see www.dell.com/support.
NOTE: : If you use a single PSU, install a blank plate in the other PSU slot. If you are only using one power supply, install the power supply in the first slot, PSU1. Install a blank plate in the second slot, PSU2.
Disconnect the power cable from the PSU.
Use the grab handle to slide the PSU out of the power supply bay.
Use the grab handle on the replacement PSU to slide it into the power
supply bay.
Attach the power cord to the replacement PSU.
NOTE: : The switch powers up when the cables are connected between the power
supply and the power source.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\