- Notes, cautions, and warnings
- About this guide
- S5048F-ON switch
- Site preparations
- S5048F-ON switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union EMC directive conformance statement
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell EMC support
Dell EMC PowerSwitch S5048F-ON Installation Guide December 2019
Four-post threaded installation
NOTE: : For more installation instructions, see the installation labels attached to the rail assembly.
- For this installation, remove the tool-less latch castings from the front side of each ReadyRails assembly. See item 1. Use a Torx screwdriver to remove the two screws from each front latch on the switch side of the rail. Remove the tool-less latch casting. Retain the castings for future rack requirements.
Figure 1. Four-post threaded round-hole installation 
- For each rail, attach the front and back flanges to the post flanges with two user-supplied screws at each end.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\