- Notes, cautions, and warnings
- Introduction to OMIMSSC
- Use cases of OMIMSSC
- Views in OMIMSSC
- Managing profiles
- Discovering devices and synchronizing servers with MSSC console
- Preparing for operating system deployment
- Managing Operational Templates
- Creating Operational Template from reference servers
- Creating Operational Template from reference Modular Systems
- Viewing Operational Template
- Modifying Operational Template
- Configuring system specific values (Pool values) using Operational Template on multiple servers
- Deleting Operational Template
- Assigning Operational Template and running Operational Template compliance for servers
- Deploying Operational Template on servers
- Assigning Operational Template for Modular Systems
- Deploying Operational Template for Modular System
- Unassigning Operational Template
- Firmware update in OMIMSSC
- Creating clusters using Operational Template
- Managing devices in OMIMSSC
- Configuration and deployment
- Appendix
- Appendix 2
- Accessing documents from the Dell EMC support site
OpenManage Integration for Microsoft System Center Version 7.2 for System Center Configuration Manager and System Center Virtual Machine Manager User’s Guide
Creating logical switch for Storage Spaces Direct clusters
About this task
NOTE: The IP address that is entered in Configuration for Management section overrides the IP address that is entered in operating system component of Storage Spaces Direct predefined Operational Template.
Steps
- In OMIMSSC, expand Configuration and Deployment, click Cluster View, and then click Create logical switch for Cluster.
- Provide a name for the logical switch, and select the host group present in SCVMM for associating the logical switch.
- Provide the following details, and click Create.
- In Configuration for Management, provide the Subnet, Start IP, End IP, DNS Server, DNS Suffix, and Gateway details.
NOTE: Provide the subnet information in Classless InterDomain Routing (CIDR) notation.
- In Configuration for Storage, provide the VLAN, Subnet, Start IP, and End IP details.
- In Configuration for Management, provide the Subnet, Start IP, End IP, DNS Server, DNS Suffix, and Gateway details.
-
enter a unique job name, description for the job, and click
Create.
To track this job, the Go to the Job List option is selected by default.
Next steps
To verify that the logical switch is created successfully, check for the logical switch name in the drop-down menu listed in Create Cluster page.
To view the details
of the logical switch, perform the following steps in SCVMM:
- To view the logical switch name, click Fabric, and in Networking, click Logical Switches.
- To view the logical switch’s Uplink Port Profile (UPP), click Fabric, and in Networking, click Logical Switches.
- To view the logical switch’s network, click Fabric, and in Networking, click Logical Networks.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\