You can discover Dell EMC devices using the Dell EMC Configuration Wizard. This wizard takes you through a series of configuration steps where you provide appropriate input required to discover the hosts and associate them with their respective services. The Dell EMC plug-in validates the inputs at the end of each step before proceeding to the next step and displays appropriate message prompts or summary.
Dell EMC recommends that you discover a maximum of 255 devices at a time for a better user experience.
The devices are discovered either through SNMP or WSMan protocol or Redfish REST APIs. The monitoring protocols for the supported devices are as follows:
Dell EMC Servers can be discovered using SNMP or WSMan protocol or Redfish. Redfish is the default protocol.
Dell EMC Chassis can be discovered using WSMan protocol.
Ensure that you only monitor Dell EMC Chassis using local user credentials.
Dell EMC Storage and Dell EMC Network Switches can be discovered using SNMP protocol.
MX7000 chassis and ME4 are discovered using REST protocol.
You can discover devices using any of the following:
Auto-Discovery Jobs – Select an auto discovery job.
Subnet – Subnet with mask.
File – File Containing a list of device IP addresses or FQDNs.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\