- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Disassembly and reassembly
- Side cover
- Front bezel
- Fan shroud
- Hard-drive assembly
- 3.5-inch hard drive
- Solid-state drive
- Memory modules
- SD card reader (optional)
- Processor fan and heat-sink assembly
- Processor
- Graphics card
- Graphical processing unit
- Coin-cell battery
- WLAN card
- Slim optical-drive
- Slim optical-drive bracket
- Voltage regulator heat sink
- Speaker
- Power button
- Power-supply unit
- Intrusion switch
- Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
- System board
- Troubleshooting
- Getting help
OptiPlex 5080 Tower Service Manual
Removing the SD card reader
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the side cover.
- Remove the fan duct.
About this task
The following images points to the location of the SD card reader and provide a visual representation of the removal procedure.
Steps
- Remove the (M3x3) screw and open the metal bracket securing the SD card reader slot.
- Remove the (M2x3.5) screw that secures the card reader to the SD card slot.
- Slide and remove the SD card reader from the connector on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\