- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Field service information
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7080 Small Form Factor Service Manual
Removing the power-supply unit
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the side cover.
- Remove the 2.5 in. hard drive assembly.
- Remove the memory modules.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the removal procedure.
Steps
- Remove the SATA cables from the retention clip on the support bracket.
- Remove the two screws (M6X32) and slide the support bracket out from the slot.
- Unroute the power-supply cable from the retention clip on the chassis.
- Remove the three screws (M6X32) that secure the power-supply unit to the back of the chassis.
- Press the power-supply unit release latch and slide the unit into the chassis.
- Remove the power-supply unit out of the chassis.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\