Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge C6320p Owner's Manual

Installing a hard drive into a hard drive carrier

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Remove the hard drive carrier from the system.
  3. If installed, remove the hard drive blank. The procedure for removing a blank is the same as removing a hard drive carrier.
  4. Keep the Phillips #2 screwdriver ready.

Steps

  1. Place the hard drive into the hard drive carrier.
  2. Secure the hard drive to the hard drive carrier with screws.
    Figure 1. Installing a hard drive into a hard drive carrier
    This image shows installing a hard drive into a hard drive carrier.
    NOTE: Ensure that the hard drive is installed with the label facing up. This is to ensure that the hard drive connector is aligned with the connector on the backplane.

Next steps

  1. Install the hard drive carrier into the hard drive bay.
  2. To check the status of the hard drive, see the hard drive activity and status indicators.
  3. To verify the status of the installed hard drive, check the management software.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\