Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge C6320p Owner's Manual

PDF

Installing the air shroud

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the sled from the enclosure.

Steps

  1. Insert the air shroud into the sled, aligning the latches with the lock slots on the sled chassis.
    NOTE: Ensure that both the SATA cables are routed through the air shroud cable guide slot behind the air shroud latches.
    NOTE: Ensure that neither of the cables are pinched or pressed under the air shroud.
  2. Press the air shroud until the locks click into place.
    Figure 1. Installing the air shroud
    This image shows the installation of the air shroud.

Next steps

  1. Install the sled into the enclosure.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\