Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge C6320p Owner's Manual

PDF

Removing an expansion card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the sled from the enclosure.
  4. Remove the expansion card riser assembly.
  5. Keep the Phillips #2 screwdriver ready.

Steps

  1. Remove the screw that secures the expansion card to the assembly.
  2. Hold the expansion card by its edges, and carefully remove it from the riser card.
    NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
    Figure 1. Removing an expansion card
    This image shows removing an expansion card.
    Figure 2. Installing an expansion card filler bracket
    This image shows installing an expansion card filler bracket

Next steps

  1. Install the expansion card or the expansion card filler bracket.
  2. Install the expansion card riser assembly.
  3. Install the sled into enclosure.
  4. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\