- Notes, cautions, and warnings
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
Dell EMC PowerEdge C6420 Installation and Service Manual
Installing the system battery
Prerequisites
WARNING There
is a danger of a new battery exploding if it is incorrectly installed.
Replace the battery only with the same or equivalent type recommended
by the manufacturer. For more information, see the safety information
that shipped with your system.
NOTE Battery is a Field Replaceable
Unit (FRU). Removal and installation procedures are to be performed
only by Dell certified service technicians.
- Follow the safety guidelines listed in Safety instructions.
- Follow the procedure listed in Before working inside your system.
Steps
- Locate the battery socket. For more information, see the System board connectors section.
- Hold the battery with the "+" facing up and slide it under the securing tabs.
- Press the battery into the connector until it snaps into place.
Figure 1. Installing the system battery 
Next steps
- If removed, install the expansion card riser.
- Follow the procedure listed in After working inside your system.
- While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
- Enter the correct time and date in the System Setup Time and Date fields.
- Exit System Setup.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\