Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge FC640 Installation and Service Manual

PDF

Installing the optional internal dual SD module

Prerequisites

Follow the safety guidelines listed in Safety instructions.
NOTE: You must install either the Internal dual SD module (IDSDM) or the BOSS M.2 card in the same IDSDM/BOSS M.2 connector.
NOTE: The procedure to install IDSDM and the BOSS M.2 card is the same.

Steps

  1. Holding both ends of the IDSDM, insert the IDSDM into the IDSDM/BOSS M.2 connector on the system board.
    NOTE: For information on the location of the IDSDM/BOSS M.2 connector, see the System board jumpers and connectors section.
  2. Push the release tab that secures the IDSDM to the system board, in place.
  3. Using the Phillips #2 screwdriver, tighten the retention screw that connects the internal dual SD module (IDSDM) to the system board.
    Figure 1. Installing the optional IDSDM module
    This image shows installing the optional internal dual SD module.

Next steps

  1. Install the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\