- Notes, cautions, and warnings
- Dell EMC PowerEdge FC640 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System Information
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- NVMe Settings
- Viewing NVMe Settings
- NVMe Settings details
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Choosing system boot mode
- Changing boot order
- Network Settings
- Viewing Network Settings
- Network Settings screen details
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure the system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Redundant OS Control
- Viewing Redundant OS Control
- Redundant OS Control screen details
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Removing the system from the enclosure
- Installing the system into the enclosure
- Inside the system
- Air shroud
- Drives
- Drive backplane
- System memory
- Processors and heat sinks
- M.2 SSD module
- Network Daughter Card
- Mezzanine card
- Storage controller card
- System battery
- Optional internal USB memory key
- Optional MicroSD or vFlash card
- IDSDM
- System board
- Trusted Platform Module
- rSPI card
- System diagnostics
- Jumpers and connectors
- Getting help
Dell EMC PowerEdge FC640 Installation and Service Manual
Removing a drive from a drive carrier
Prerequisites
- Follow the safety guidelines listed in Safety instructions.
- Remove the drive carrier from the system
Steps
- Using the Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
- Lift the drive out of the drive carrier.
Figure 1. Removing the drive from the drive carrier 
Next steps
If applicable, install a drive into the drive carrier.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\