Configuring The CMC Using A Management Station And CLI
The LCD configuration wizard is the quickest way to initially configure the CMC network settings. However, you can also use a management station and a local connection to access the CMC.
About this task
There are two ways to create a local connection to the CMC:
The CMC Console, using the optional iKVM. Press <Prnt Scrn> and select blade number 17.
Serial connection, using an optional null modem cable (115200 bps, 8 data bits, no parity, 1 stop bit, and no flow control).
Once you have established a connection to the CMC, you can complete the initial CMC network configuration.
Steps
Log in to the CMC.
The default user name is
root and the default password is
calvin.
Type
getniccfg and press <Enter> to view the current CMC network parameters.
Configure the CMC network settings:
To set a static IP address, type
setniccfg -s <IP address><network mask><gateway>
and press <Enter>.
To configure the CMC to obtain an IP address using DHCP, type
setniccfg -d
and press <Enter>.
The new network settings are activated in a few seconds after configuring the network.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\