Configuring
The CMC Using The LCD Configuration Wizard
Prerequisites
When you
first boot your system, the screen on the LCD module directs you
to configure the CMC network settings.
NOTE: The option to configure
the enclosure using the LCD configuration wizard is only available
until the CMC default password is changed or when the LCD configuration
wizard is complete. Thereafter, use the RACADM CLI or the web-based
GUI to change the CMC settings.
NOTE: The serial null modem
cable for the CMC is an option. You can access the CLI using the
17th blade feature on the embedded iKVM module. Blade number 17 is
a direct local connection to the CMC.
Steps
Choose a language from the options in the dialog box.
Start the LCD configuration wizard.
Configure the CMC network settings for your network environment.
Network speed
Duplex mode
Protocol (IPv4 and/or IPv6)
Network mode (DHCP or static)
Static IP address, subnet mask, and gateway values (if static
mode was selected)
DNS setting, including a registered CMC name, (if DHCP mode was
selected)
NOTE: The CMC
external management network mode is set by default to DHCP. To use
a static IP address, you must change the setting using the LCD configuration
wizard.
If required, configure the iDRAC network setting for DHCP
mode.
NOTE: You cannot
set a static IP address for the iDRAC using the LCD configuration
wizard. To set the static IP address, use the web-based interface.
Review the settings on the Network Summary screen:
If the settings are correct, press the center button to close
the configuration wizard and return to the Main Menu.
If the settings are not correct, use the left-arrow key to return
to the screen for that setting and make the appropriate changes.
The Network Summary screen lists the
IP addresses for the CMC and the iDRAC network settings.
Next steps
After you
complete the LCD configuration wizard, you can access the CMC on
the network using the web-based CMC interface or text-based interfaces
such as a serial console, Telnet, or SSH.
NOTE: If you want to use
static addresses rather than DHCP to access the iDRACs, you must
configure them using the CMC web-based interface or CLI.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\