Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge MX5016s and MX5000s Installation and Service Manual

PDF

Removing aMX5016s module from Fabric C slot

Prerequisites

NOTE MX5016s storage sled does not support single SAS IOM configuration.
  1. Follow the safety guidelines listed in Safety instructions.
  2. If applicable, disconnect the cables that are connected to the modules.

Steps

  1. Press the orange release button on the module to open the release lever.
  2. Hold the release lever, and pull the I/O module out of the enclosure.
    NOTE Ensure that you install MX5000s blank if you are removing a module permanently.
    Figure 1. Removing aMX5000s module from Fabric C slot
    This image shows how to remove a module from Fabric C.

Next steps

  1. Install a module into Fabric C or Install a blank.
  2. Connect the cables to the module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\