- Notes, cautions, and warnings
- About this document
- PowerEdge MX740c sled overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX740c sled
- System cover
- Air shroud
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC card
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge MX740c Installation and Service Manual
Inside the system
NOTE Components that are hot swappable have orange touch points and the
components that are not hot swappable have blue touch points.
- Backplane
- Backplane cable
- Processor 1 (heat sink)
- Processor 2 (heat sink)
- Mezzanine card A1
- Power connector
- Mezzanine card B1
- Mini Mezzanine connector
- iDRAC card
- BOSS connector
- PERC connector
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\