Dell EMC PowerEdge MX740c Installation and Service Manual

Removing the sled from enclosure

1. Press the blue release button on the sled to release the sled handle.
2. Holding the sled handle, slide the sled out of the enclosure.
   NOTE Support the system with both hands while sliding it out of the enclosure.

   NOTE Removing the sled with the enclosure powered on is supported if you shut down the sled before removal.

   

3. Install the I/O connector cover on the sled.
   CAUTION To protect the I/O connector pins, install the I/O connector cover every time a sled is removed from the enclosure.

   

   NOTE The color of the I/O connector cover may differ.

   CAUTION If you are permanently removing the sled, install a sled blank promptly. Operating the enclosure without a blank, for an extended time can result in overheating or performance loss.