- Notes, cautions, and warnings
- About this document
- PowerEdge MX740c sled overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX740c sled
- System cover
- Air shroud
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC card
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge MX740c Installation and Service Manual
Installing the drive cage
Prerequisites
- Follow the safety guidelines listed in Safety Instructions.
- Follow the procedure listed in Before working inside the sled.
Steps
- Place the drive cage into the system, aligning with the screw holes on the system.
- Using the Phillips #1 screwdriver, secure the drive cage in place
with screws.
Figure 1. Installing the drive cage 
Next steps
- Install the drive backplane.
- Install the drives.
- Follow the procedure listed in After working inside your sled.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\