Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge MX740c Installation and Service Manual

PDF

Installing the PERC card

Prerequisites

  1. Follow the safety guidelines listed in Safety Instructions.
  2. Follow the procedure listed in Before working inside the sled.

Steps

  1. Pull the blue pull tag to raise the lever up on the PERC card.
  2. Align the connector on the PERC card with the connector on the system board.
    NOTE The procedure to install the HBA330 MX or a H730P MX PERC card is the same.
    NOTE The MX740c supports both HBA330 MX or H730P MX PERC card.
  3. Align the guides on the PERC card with the slots on the system.
  4. Press the PERC card to firmly seat in the system board connector.
    Figure 1. Installing the PERC card
    This image shows how to install the PERC card.
  5. Close the lever on the PERC card.

Next steps

  1. Connect the cable to the PERC card.
  2. Follow the procedure listed in After working inside your sled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\