The LEDs on the drive carrier indicates the state of each drive. Each drive carrier in your system has two LEDs: an activity LED (green) and a status LED (bicolor, green/amber). The activity LED flashes whenever the drive is accessed.
NOTE:If the
drive is in the Advanced Host Controller Interface (AHCI) mode, the
status LED indicator does not turn on.
Table 1. Drive indicator
codesThe drive indicator codes table describes the indicator
codes: flashing green twice per second, Off, flashes green, amber,
and then turns off, flashes amber four times per second, flashes green
slowly, solid green, flashes green for three seconds, amber for three
seconds, and then turns off after six seconds.
Drive status
indicator code
Condition
Flashes
green twice per second
Identifying
drive or preparing for removal.
Off
Drive ready for
removal.
NOTE:The drive
status indicator remains off until all drives are initialized after
the system is turned on. Drives are
not ready for removal during this time.
Flashes green,
amber, and then turns off
Predicted
drive failure.
Flashes
amber four times per second
Drive
failed.
Flashes
green slowly
Drive
rebuilding.
Solid
green
Drive
online.
Flashes green for three seconds, amber for
three seconds, and then turns off after six seconds
Rebuild stopped.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\