Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R340 Installation and Service Manual

PDF

Removing the intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Keep the plastic scribe ready.

Steps

  1. Disconnect and remove the intrusion switch cable connector from connector on the system board.
    NOTE Observe the routing of the cable as you remove it from the system.
  2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
    Figure 1. Removing the intrusion switch

    This image shows how to remove the intrusion switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\