Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R750 Installation and Service Manual

PDF

Installing an expansion card into the expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If installing a new expansion card, unpack it and prepare the card for installation.
    NOTE:For instructions, see the documentation accompanying the card.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the system warranty.

Steps

  1. Pull and lift up the expansion card retention latch lock to open.
  2. If installed, remove the filler bracket.
    NOTE:Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
    Figure 1. Removing the filler bracket
    This image shows Removing the filler bracket.
  3. Hold the card by edges, and align the card with the connector on the riser.
  4. Insert the card firmly into the expansion card connector until seated.
  5. Close the expansion card retention latch.
  6. Push the card holder to hold the card in the riser.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 2. Installing an expansion card into the expansion card riser
    This image shows Installing an expansion card into the expansion card riser.

Next steps

  1. If applicable, connect the cables to the expansion card.
  2. Install the expansion card risers.
  3. Follow the procedure listed in After working inside your system.
  4. Install any device drivers required for the card as described in the documentation for the card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\