Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge RAID Controller 9 User’s Guide H330, H730, and H830

PDF

Removing the HBA330 mini monolithic controller

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE:It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. Open the system.
  3. Locate the HBA card on the system board
  4. To disconnect the storage controller cable:

    1. Remove the two screws that secure the cable to the card.

    2. Grasp the cable on both sides of the cable connector, and pull the cable up and away from the HBA card.

  5. Angle the card so that the other end of the card disengages from the storage-controller card holder on the system board.
  6. If applicable, replace the storage controller card and connect the cable. For more information on installing the card, see Installing the HBA330 mini monolithic controller.
  7. Close the system.
  8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
    Figure 1. Removing and installing the HBA330 mini monolithic card
    This figure shows removing and installing the HBA330 mini monolithic card.
    1. storage controller cable
    2. storage controller card
    3. storage-controller card holder
    4. storage controller retention hook

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\