WARNING - Found
virtual disks that are degraded and failed
This warning message is displayed when multiple virtual disks are
in Degraded and Failed state and Pause if Degraded or Pause if Failed are set to ON at the BIOS Configuration Utility Ctrl+R.
The following message is displayed after the
warning is displayed: --- Press Enter to
continue, or Ctrl+R to enter setup --- .
Press <Enter> to allow the operating system to continue
its boot, or press Ctrl+R to enter into the BIOS
Configuration Utility Ctrl+R to investigate
the cause of the Degraded and Failed virtual disks.
NOTE: A boot virtual disk
that is in a Failed state prevents the operating
system from booting.
To investigate the cause,
check for the following:
Whether the virtual disk is in Degraded status because one of the physical disks of
a RAID 1 or RAID 5 virtual disk has failed, or one of the physical
disks of a RAID 10 virtual disk has failed. Press Ctrl+R
and verify if the physical disks are offline or missing. Remove and
replace a failed physical disk. A second physical disk failure could
cause a Degraded virtual disk to change to Failed status.
Whether the virtual disk is in a Failed status because one or more of the physical disks
have failed. Press Ctrl+R and verify if the physical disks
are offline or missing. Remove and replace the failed physical disk
or disks.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\