Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T20 Owner's Manual

PDF

Removing the power supply unit

  1. Disconnect the P1 and P2 power cables from the power supply unit (PSU) to the system board connectors.
  2. Remove the screws securing the PSU to the chassis.
  3. Press the release tab beside the power supply unit, and slide the PSU towards the front of the system.
  4. Lift the PSU out of the system.
    Figure 1. Removing and Installing the Power Supply Unit The figure shows removing and installing the power supply unit.
    1. P1 power cable
    2. P2 power cable
    3. release tab
    4. power supply unit
    5. screws (4)
    Figure 2. Removing the power supply unit This figure shows removing the power supply unit.
  1. Install the power supply unit.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\