Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerStore Installation and Service Guide for PowerStore 1000, 1200, 3000, 3200, 5000, 5200, 7000, 9000, and 9200

PDF

Install the node

Steps

  1. Align the pins on the top of the node with the grooves on the top of the chassis.
  2. Slide the node into the chassis until it stops, about halfway in.
    Figure 1. Sliding the node halfway into the chassis
    Sliding the node halfway into the chassis
  3. Pull the black release tab out completely, and slide the rest of the node back into the chassis.
    The black release tab slides back into the system as it is inserted.
    Figure 2. Installing the node
    Installing the node
  4. Reconnect the back-end cables and the cables to the I/O modules and network ports.
  5. Pull the orange release trigger and push in gently to re-engage the locking mechanism.
    If the black release tab comes out when pulled, the locking mechanism is not engaged.
  6. Plug in the power cable immediately after installing the node.
    CAUTION:Failure to plug in the power cable could prevent required firmware upgrades from completing.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\