Dell PowerStore Hardware Information Guide for PowerStore 1000, 1200, 3000, 3200, 5000, 5200, 7000, 9000, and 9200

PDF

Power requirements for the NVMe expansion enclosure

Power requirements vary depending on system configuration, loading, and environmental conditions. The table below describes the maximum expected power draw. To estimate power consumption values for your specific environment, go to https://powercalculator.dellemc.com/.

Table 1. Power requirements
Requirement	Description
AC line voltage	100 to 240 VAC +/- 10%, single-phase, 47 to 63 Hz
AC line current (operating maximum)	6.49 A max at 100 VAC
AC line current (operating maximum)	3.31 A max at 200 VAC
Power consumption (operating maximum at 200 VAC)	663 VA (630 W)
Power factor	0.92 minimum at full load 100V/200V
Heat dissipation (operating maximum at 200 VAC)	0.92 minimum at full load 100V/200V
Heat dissipation (operating maximum at 200 VAC)	2.27 x 10⁶ J/hr (2,150 Btu/hr)
In-rush current	82A max for 1/2 Line cycle per line cord at 200 VAC
Startup surge current	100A Max for up to 125uSec
AC protection	15 A fuse on each power supply, both Line and Neutral
AC inlet type	IEC320-C14 appliance coupler, per power zone
Ride-through time	10-millisecond minimum
Current sharing	+/- 5% of full load between power supplies