Remote replication
groups require a 10-minute interval between automatic and manual synchronizations.
If you request a manual synchronization when a Remote Replication
group is inside a 10-minute synchronization interval, the manual synchronization
does not begin until the previous synchronization interval has passed.
This interval may cause a delay in the SRM workflow process which
requires several synchronization operations to occur during test failover
and/or failover workflows. SRA is optimized to avoid requesting a
manual synchronization if no changes are detected within the Remote
Replication group. However, if changes are detected, a synchronization
is requested. The effect may be observed as a lack of progress or
slow progress through SRM workflows.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\