With added
support for Remote Replication over iSCSI protocol, greater replication
distances are now possible. However, this improvement in replication
distances impacts latency (compared to earlier Fibre Channel-only
support). Therefore, take careful consideration during Datastore creation
to ensure that only data that must be replicated is included on the
virtual disks you replicate. After replication begins, closely observe
the amount of data being replicated and the time it takes to synchronize
data. If the amount of time required to synchronize data is more than
the synchronization interval, a remote replication group becomes degraded
and nonfunctional.
Proper sizing of your network
infrastructure is a critical component of a successful disaster recovery
solution. For more information, see the following documentation:
Dell PowerVault MD Series Storage
Arrays Administrator's Guide
at
Dell.com/support/manuals.
VMware Site Recovery Manager Documentation Center
at
vmware.com/support/pubs.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\